- Inicio
- Modelar
- Moldes y Réplicas
- sellar y liberar
- Buddy Rhodes
- Pigments & Paints
- Pigments
- FFX BC-series pigment
- FFX S-series Pigment
- Polyester Pigment
- Polvos metálicos y Sprays
- Glow Worm Pigmentos
- Tintes Ignite
- CastMagic Powders
- Cryptolyte
- Tintes SO-Strong
- Flock fibras
- EPTone Pigments
- Silcpig pigmentos
- SilTone
- SilTone Kits
- Key-Pigments Silicone Pigments
- SAM (Silicona Arts Materials)
- Pigmentos en polvo
- Latex Pigmentos
- UVO Pigmentos resistentes al UV
- SilcPig Electric
- Paints
- Psycho Paint
- Pátinas
- Quarry Tone, Cargas
- Polvos metálicos
- Polvos Metálicos de imitación
- MM Latex Paint Base
- Monster Makers Permawet
- Bond FX
- Vallejo Imprimaciones y Lacas
- Pigments
- Jesmonite
- Aditivos
- Disolventes y diluyentes
- Adhesivos
- Herramientas
- Equipos
- FX Lab
- SFX On-Set
- Ayuda para elegir
- Marcas
- DVD's & Revistas
NOVOCS™ Gloss
NOVOCS™ solvents are low viscosity silicone solvents that evaporate quickly. NOVOCS™ is particulary useful in thinning down Psycho Paint® silicone paint base to apply via brush or airbrush to cured platinum silicone rubber props and prosthetics. When used as a solvent for thinning silicone paints or surface coatings, NOVOCS™ Gloss will leave a gloss finish. WARNING - FLAMMABLE Liquid and vapor. Keep away from ignition sources and follow precautions for handling flammables.
Instructions
Materials should be stored and used in a warm environment (73°F / 23°C). This material has a limited shelf life and should be used as soon as possible. Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk.
Mix the A and B components of two component silicone sytems before adding NOVOCS™. Add the desired proportion of NOVOCS™ solvent to create a thinner silicone mixture which can be brushed or airbrushed onto the surface of a cured silicone casting.
Example Recommended Ratios For Use:
When adding to Psycho Paint, add between 200%-400% NOVOCS™ solvent by weight
When adding to Sil-Poxy, add between 300%-500% NOVOCS™ solvent by weight
Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.